滾動碼遙控器學習方法

1、學習、滾動碼遙控器學習方法（SR500C） 1、按0.5秒接收板上的學習按鈕，然后連續按住需要配套的遙控器遙控器上任意一個按鍵2秒鐘，即可完成學習過程，如果要增加遙控器可以重復以上過程，接收板最多可以學習15個遙控器。接收板或遙控器長期斷電也能記憶已經學習成功的遙控器。2、 如果連續按住接收板上的學習按鈕超過8秒，接收板上的指示燈會熄滅，可以全部刪除所有已經學習的遙控器。（在遙控器丟失的情況下可以用此方法）刪除:按住學習按鍵不放，直到學習指示燈熄滅，控制里學習過的遙控器全部刪除。 3、該“學習”的功能可廢除舊“鑰匙”配制新“鑰匙”，如果遙控發射器丟失，也不必?fù)?dān)心，重新配一個即可。 4、現在使用

2、的301用電子運算法，與汽車遙控鑰匙相同；32位元密碼（2的32次方），能提供超過40億種的組合。即40多億個不會重復。 B常閉；G公共；K常開；L鎖存；M點動SR500C ROLLING CODE RECEIVER BOARD MANUALPROGRAM A TRANSMITTER TO THE RECEIVERYou need to do the programming in order to add the transmitter to thereceiver.1. Press and hold the learn button on the left side of the recei

3、ver board for 0.5 second.2. Press any assigned button of the transmitter you want to program to the receiver continuously for 2 seconds, then the programming will be completed.3. To program another transmitter to the receiver, repeat process 1 to 2.NOTE1. One receiver board can handle up to 15 trans

4、mitters, once programmed, both the transmitter and the receiver will store the information for a long term even if the power supply is cut off.REMOVE TRANSMITTER FROM THE RECEIVERYou can delete the transmitter from a receiver.1. Press and hold the learn button on the left side of the receiver board

5、for 8 seconds, the LED on the receiver will be extinguished, All the transmitters and keypads are deleted. ( This will be useful if you lost your transmitter. )NOTE1. Our product is equipped with HCS301 which utilizes Microchips patented KEELOQ® hopping technology which incorporates high security, th