面試問題庫Top300+項CCIE面試名問題

1、EIGRP What is Quality of Service (QoS)? What are congest!on, delay, and jitter? What is the MQC? What does the service-policy is supported only onVIP interfaces with DCEF enabled message mean? How many classes does a Quality of Service (QoS)policy support? How are routing updates and Point-to-PointP

2、rotocol (PPP) / High-Level Data Link Control (HDLC) keepalives processed whena service policy is applied? Is Quality of Service (QoS) supported oninterfaces configured withIntegrated Routing and Bridging (IRB)? What is Quality of Service (QoS)pre-classification? Which packet header fields can be rem

3、arked? Whatvalues are available? Can I prioritize traffic based on the URL? What platforms and Cisco IOS software versionssupport Network Based Application Recognition (NBAR)? What is the purpose of queueing? How do Weighted Fair Queueing (WFQ) and ClassBased Weighted Fair Queueing (CBWFQ) operate?

4、If a class in Class Based Weighted Fair Queueing(CBWFQ) is not using its bandwidth, can other classes use the bandwidth?IsClass Based Weighted Fair Queueing (CBWFQ) supported on subinterfaces? Is Class Based Weighted Fair Queueing (CBWFQ)supported on subi nterfaces? What is the difference between th

5、e priority andbandwidth statements in a policy-map? How is the queue limit calculated on the FlexWANand Versatile Interface Processors (VIP)? How do you verify the queue-limit value? Can I enable fair queueing inside a class? What commands can I use to monitor queueing? RSVP can be used in conjunct!

6、on with Class BasedWeighted Fair Queueing (CBWFQ). When both Resource Reservation Protocol (RSVP)and CBWFQ are configured for an interface, do RSVP and CBWFQ act in dependently,exhibiting the same behavior that they would if each were running alone? RSVPseems to behave as if CBWFQ is not configured

7、regarding bandwidth availability,assessment, and allocation. Can I enabled Weighted Random Early Detection(WRED) and Low Latency Queueing (LLQ)r or Class Based Weighted Fair Queueing(CBWFQ) at the same time? How can I monitor Weighted Random Early Detection(WRED) and see it actually taking effect? W

8、hat is the difference between policing andshaping? What is a token bucket and how does the algorithmwork? With a traffic policer such as class-basedpolicing, what do Committed Burst (BC) and Excess Burst (Be) mean and howshould I select these values? How does Committed Access Rate (CAR) orclass-base

9、d policing decide if a packet con forms or exceeds the Committedlnformation Rate (CIR)? The router is dropping packets and reporting anexceeded rate eve n though the conformed rate is less tha n the con figured CIR Are the burst and queue limit independent of eachother? What values should I select f

10、or Committedlnformation Rate (CIR), Committed Burst (BC), Excess Burst (Be), and MinimumCIR (MinCIR)? Does Priority Queueing on the Frame Relay maininterface work in Cisco IOS 12.1? Does Frame Relay Traffic Shaping (FRTS) work withDistributed Cisco Express Forwarding (dCEF) and Distributed Class Bas

11、edWeighted Fair Queueing (dCBWFQ)? Where do I apply a service policy with Class BasedWeighted Fair Queueing (CBWFQ) and Low Latency Queueing (LLQ) onanAsyn chr onous Transfer Mode (ATM) in terface? What bytes are counted by IP to AsynchronousTransfer Mode (ATM) Class of Service (COs) queueing? How many Virtual Circuits (VCS) can support aservice policy simultaneously? Which Asynchronous Transfer Mode (ATM) hardwaresupports IP to ATM Class of Service (COs) features including Clas