牙科治療機-出廠檢驗單(quan)

1、版本號edition B 產品編號Product No.序號No.檢驗結果CheckoutResult 單項結論Conclusion44.4.2.2 當水壓為200kpa 時,抽水速率應不小于500ml/min 。When the water pressure is 200kpa, pump water speed should not be less than 500ml/min.2 4.4.2.1 當水壓為200kpa 時,真空度應不抵于27kpa 。When the water pressure is 200kpa,the vacuum should not be less than 3

2、5kpa.4.5.7 口腔燈在最大照度地,其色溫應在30005000k 。The Max color temperature should be 30005000k4.5.3 口腔燈反光器上冷光膜層應均勻,結合牢固,不應有明顯的針孔、水漬、花斑和脫膜現象。The luminescence film of operating lamp should be uniformity, there is no pinhole and watertrack and speckl and miss out film.4.5.4 口腔燈的照度應不小于20000 lux 。brightness of the o

3、perating lamp should not be less than 25000 lux4.6 觀片燈的光色呈乳白色,通電后10s 鐘內應發光,無抖動現象,屏幕中心亮度大于2000 lux 。The light of viewing lamp should be ivory-white,it should have the light in 10s after connectingpower supply and there is no dithering and the brightness of screen center should be more than2000 lux牙科治

4、療機 -產品出廠檢驗單Product Final Inspection Record1產品型號Product Type文件編號Controlled No.BG-ZGB-13.B檢驗依據InspectionCriteria標準規定內容Content of Standard 4.3.1 三用噴槍按結構不同,可噴出常溫或加溫的噴出物 。Three way spraying gun can spray normal temperature and added temperature air or water according to different structure3 4.5.1 口腔燈應能在燈

5、臂上活動靈活,并能穩定停留在所需位子上,不受外力作用時,不應改變原來的位子。The operating lamp movement should be agility and stop on you need, there is no outside force, the station should not be changed.AM 系列牙科綜合治療機YZB/蘇XXXX-2009AM Series Dental unit YZB/蘇XXXX-20094.5.5 口腔燈的光斑在相距燈平面725mm 處,照明區域應為(70±15×(140±30mm 2。Light

6、 spot of the otherating lamp lighting area should be (70±15×(140±30mm 2 at the 725mm awayfrom lamp.4.5.8 口腔燈照度在20000 lux 時,在照明區中任何一點上,溫升不大于80C 。When the operating lamp brightness is 25000lux,the temperature rising of any point in the lightarea should be not more than 8ºC4.3.3 分別按

7、動三用噴槍的水路或氣路按扭時,水、氣應分清,兩個按扭同時按下時,噴出物應成霧狀。When Press the water or air switch ,the water and air should be separate each other,when you press water and air switch at the same time ,gusher should be fog4.4.3.1 當氣壓為550kpa 時,真空度不低于27kpa 。When the air pressure is 500kpa,the vacuum should not be less than 2

8、7kpa.4.4.3.2 當氣壓為550kpa 時,抽氣速率應不小于380ml/min 。When the air pressure is 500kpa, pump air speed should not be less than 380ml/min4.4.3.3 氣吸引系統應裝有固體收集器,該收集器應過濾2mm 以上的固體顆粒。Solid gather implement should be installed in The air suction system and it should leach solidgranule above 2mm.4.5.2 口腔燈應具有保險限位裝置。Th

9、e operating lamp should have safety limit setting.4.3.2 三用噴槍的密封性應良好,啟閉應靈活,噴出物應均勻,噴射方向應能調節。Three way spraying Seal shoud be better and up/close should be agility and gusher should be uniformat and spraying type should be adjusted4.5.6 口腔燈射在屏幕上的光應呈白色。The light on the screen of operating lamp should be white .4.7.3 有熱水器的,則恒溫性能應穩定,嗽口水溫為40±50C 。4.8.1 痰盂的材料應能經受消毒劑或清洗劑的消毒清洗而無損壞。Material of Cuspidor should not be damage when use the disinfector or cleaner5 4.7.1 出水應柔直,無漂濺現象。Th