手機跌落測試標準

1、Test specificationTest nameDROP TEST FOR UNPACKED APPARATUSEvaluate the shock resistance of an apparatus unpacked to resist a series of drop tests.評估無包裝的儀器的耐震強度來進行一系列下落測試1. STANDARD標準This test is according to the standard NFC 20 732 equivalent to the standard CEI 68-2-32此測試根據等同于標準cei68-2-32的標準nfc207

2、322. PRINCIPLE原理The test samples suffer 14 successive drops with different angles on a pinewood board.測試樣品滿足14次連續不同角度下落在松木板上3. DIRECTIONS FOR USE :使用方向3.1 Test surface測試表面Pinewood board of 5 cm thickness5cm厚度的松木板3.2 Dropping height下落高度The height shall be measured from the part of the specimen neares

3、t to the test surface, when the specimen is suspended prior to letting it fall.Its 1.5 m當樣品懸掛好時,下落高度應從最靠近測試表面的樣品的部分來測試3.3 Method of release釋放方法The method of releasing the specimen shall be such as to allow free fall from the position of suspension, with a minimum of disturbance at the moment of rele

4、ase.釋放樣品的方法應是伴隨釋放時擾動的最小值,從懸掛處自由落體3.4 Initial measurements首次測試The specimen shall be visually examinated and electrically and mechanically checked.樣品外觀要檢查,電力方面和機械方面也要檢查Points to check :· Switch on and off the mobile開關手機· All buttons/keys are functioning.所有的按鈕都要檢查是否能使用· Transaction

5、with SIM card處理sim卡· Check that all the pixels are functional (Use the specified function of the software for this test. Example for BE1 and BE3, type 000000* then choose the function “checker”).檢查所有像素使用供測試用的專門軟間,比如be1,be3· Check the communication檢查通訊3.5 Number of products minimum產品最小值3 ap

6、paratus minimum must be tested.三個儀器的最小值必須被檢查3.6 During the test測試時14 consecutive drop tests on all the faces as defined in the diagram : one on each face and corner while the apparatus is working. Even if the apparatus doesnt fall on the face or corner desired, the drop isnt done again.所有表面上的14個連續下落

7、測試如圖表中定義的:當儀器在運轉中,每一個表面和角落上的.即使儀器沒有下落在理想的表面或角落上,下落也無須再做1次The battery, unless a contrary request, must not be fixed with an external tool.除非有相反的要求,否則電池組無須固定在外部工具上Between each drop, the specimen shall be visually examinated and electrically and mechanically checked.在每一次下落間, 樣品外觀要檢查,電力方面和機械方面也要檢查Points

8、 to check :· Switch on and off the mobile開關手機· All buttons/keys are functioning.所有的按鈕都要檢查是否能使用· Transaction with SIM card處理sim卡· Check that all the pixels are functional (Use the specified function of the software for this test. Example for BE1 and BE3, type 000000* then cho

9、ose the function “checker”).1412檢查所有像素使用供測試用的專門軟間,比如be1,be3· Check the communication檢查通訊4819213511610374. JUDGEMENT判斷The specimen shall be visually examinated and electrically and mechanically checked after each drop.在每一次下落后,樣品外觀要檢查,電力方面和機械方面也要檢查· Checking performances of equipment.檢查設備的性能

10、- Possibility to switch on and off the mobile開關手機- Mobile stay switched on alone手機保持單獨打開- All buttons/keys are functioning. 所有的按鈕都要檢查是否能使用- Transaction with SIM card possible. 處理sim卡- Check that all the pixels are functional (Use the specified function of the software for this test. Example for BE1 and BE3, type 000000* then choose the function “checker”).檢查所有像素使用供測試用的專門軟間,比如be1,be3- Check that communication is possible.檢查通訊· Check the aspect of the equipment after the falling:在下落后,檢查儀器的每一方面- no injury