礦場管理用例測試

更改記序號1A2M3456789A–增加M–修改D–概 硬件準 測試前準 測試策 功能測 設備登 設備狀態輪 查詢的信息命 礦池管 性能測 多cell登 輪詢多個 向多個cell發送命 給多個cell分配礦 多個cell通信中 覆蓋測 命令邊界值測 概硬件準3264linuxubuntu3232系統編譯出的程序，6464sudoapt-get-yinstallmysql-serversudoapt-get-yinstallmysql-安裝mysql庫安裝sudoapt-getinstalllibmysql++-devmysql-urootgrantallon*.*toswitch@localhostidentifiedby'sf123';5）switch登錄數據庫mysql-uswitch-pcreatedatabasecell;createdatabase測試前準cell_baecell_statuscell_delcellidswitch_baepol_cof，打開tcp測試工具創建一個TCP 連接填寫對應switch2的ip,port是33000，如圖1所示；圖sf圖測試策 terminal終端發送命令，設備登開發人用例作設計日測試類手工測測試工無一、獲得dev_id（get_cellid0示預置條件：cell錄，啟動switch2。get_cellid0select*from“CellIdListis“Emptysetcellid）switch2，cell只有1cellget_cellid0get_cell11select*fromcell_id功，select*則可以顯示cell息一、沒有cell預置條件：celldel_cellisempty!”。二、有一個cellcell預置條件：只有1del_cellget_cell1get_delcellid0select*fromselect*from；“CellIdListis“CellIdListis“Emptyset |cell_id 1 1rowinset(0.00sec)三、5右cell登cell5get_cell1get_delcellid0select*fromselect*“CellIdListis“Emptyset(0.00sec)”；重新啟動預置條件：只有1switch2get_cellid0get_cell11；cell_iddev_id獲得cell息獲得登錄cell個數，的cell數，cellid刪除的delcellidswitch2間更新設備ip、cell錄get_cell1fromcell.cell_basewherecell_id=1;2.斷開cell，改變cellip變get_cell1fromcell.cell_basewherecell_id=1;。1.比cell的前后ipport，前后cell_ip開發人用例作設計日測試類手工測測試工無把接受到的cellcell錄mysql輸入selectcount(*)fromselect*獲得cellstatus，cell_status獲得cellstatus細3鐘后沒有收到cell后關閉cell，超過3select*from中看到cellid=1中看到CellId:1重啟啟動中看到CellId:1cell錄get_cell1select*from2.斷開cell于3get_cell1select*from對比cell的cell錄get_cell1select*from2.cellget_cell1select*from開發人用例作設計日測試類手工測測試工無一、一個cell預置條件：有一個cell已經登錄,cellid為 12all啟成預置條件：有兩個cell已經登錄，id=2reboot_cellall三分鐘后id=2中斷，get_cell22reboot_cellall3鐘，會返回“2Thesecell_idsetting預置條件：有兩個cell已經登錄，id=1，id=2reboot_cellallallid=1、id=2開時間超過3 12mcu 12fpga 12bd1 12bd2 12bd3mcu啟成fpgabd1啟成bd2啟成bd3啟成1.reboot_cellallmcu2.reboot_cellallfpga3.reboot_cellallbd14.reboot_cellallbd25.reboot_cellallbd3同二、 cell重復設備登錄過程4.1.12.斷開與cell 設置cell燈ormal狀（1s、交mcu制 12on 12off 12flash 12normal5.斷開與cell 12normalon功，off置成flashnormal置，有nonce30450斷開與cellset_freq1450如果BTC<C更固id復 對應的cell出廠switch_debug.log件斷開與cell ，cell空g件中看到，d,866,Create0!=1is查詢的信息命開發人用例作設計日測試類手工測測試工無S幫S獲得switch（2）被刪除一個cell錄del_cell1switchdataserver創建一個TCPserver,端為：8989，啟動switch后，在TCPserver連接成功后，發創建一個 switchdataserver開發人用例作設計日測試類手工測測試工無h一、switch時后立即送dataserverestamp":""}1.每隔60h"abcdefabcdereg_time":,"1.dataserver一、switchcell.reboot應的cell其中0/1/2/3asTCPserver 其中param的0/1/2/3as一、設置1 l","param":[[ switch回獲得cellCell中可以獲得setpool],[ 1.switch回l","param":[[搜cell設備測試用例Cell _10000_DUAL還可以接受switch2發送 gccCell_10000_DUAL.ccJSON.c-oCell_10000_DUAL-lm-./Cell發送令，gcc .ccJSON.c-o -./Cell abcdef12cellcell開發人用例作設計日測試類手工測測試工無1.查詢switch132ubuntu系0H--9M--2.get_cellid10001（Cellcell_id3.返回110001cell錄到switch22.get_cellid003.get_cell110001個cell10接完selectcount(*)5.select*--cell.cell_base|count(*) 10001Cell 1rowin(0.009960據輪詢多個開發人用例作設計日測試類手工測測試工無switch21鐘給10001預置條件：有10001cell錄selectcount(*)fromselect*fromcell.cell_statuslimit--|count(*) 30003 1rowinset(0.00cell_id=99569960態數據cell向多個cell命開發人用例作設計日測試類手工測測試工無預置條件：有10001回cell錄cell的一reboot_cell10001 um:1”Cell 預置條件：有10001，“mandN3.219上看到cellcell錄reboot_cellallCell預置條件：有100011.時間不超過cellcell斷開的cell_idcell_id1.reboot_cellall預置條件：有10001cell重啟通信，在0.75“./Cell0查看文get_cell10002reboot_cellallreboot_cellallallg件中看到10001出“CellId01iserror”信息；（因?yàn)閏ell保存cell_idcell，后看到有10002get_cell到dev_id123456Thesecell_id超過3會；1002個celll_1000DUALCelreboot_cellall12.reboot_cellall13.reboot_cell14.reboot_cellall15.reboot_cellall16.reboot_cellall預置條件：有10001 um:1” cell錄cellcell_reloginCell預置條件：有10001；“mandNcell錄cell_reloginCell預置條件：有10001Cell“These通cell查返回信cell_relogin2.超過3cell_reloginflash預置條件：有10001cell錄reset_flash復預置條件：有10001cell斷開小于3reset_flashreset_flashall“Thesecell_idcell給多個cell開發人用例作設計日測試類手工測測試工無給多個cell預置條件：有10001cell單獨的cell登錄3。1.set_poolbtc,1ltc,23.set_cell14.get_cell1100025.cell_reloginCell打印信ok,pleasecell；cell多個cell中開發人用例作設計日測試類手工測測試工無測試多個cell預置條件：有10001cell單獨的cell通信,超過3鐘。selectcount(*)fromselect*fromlimit9950,10;打開Cell_1000DUALswith_dbuglog |count(*) 10002 1rowinset(0.00sec)，說可以看到9960g件中，會看到“CellId:110001g件中，會看到“CellId:110001息開發人用例作設計日測試類手工測測試工無doesnot一、cell_id1.reboot_cell88888layer,IDdoesnotexist!”；只支持all/1.reboot_cell11.返回“Nosuchcell_id在cell_relogin888882.cell_reloginallllayerIDdoesnotexist!”一、cell_idset_cell_led88888set_cell_led88888set_cell_led888884.set_cell_led88888layerIDdoesnotexist!”set_cell_led1返回“NosuchLEDfunction!”cell_id1.set_freq88888layer,IDdoesnotexist!”cell_id在1.reset_flash888882.reset_flashallllayerIDdoesnot多個cell中開發人用例作設計日測試類手工測測試工無一、pool_idpool_id11.add_pool3zcf2poolgood.1xx“AddPool,pool_idalready1.add_pool3zcf2poolgood.1 berofparametersiserror,orpleasechecktheendofthe1.add_pool3zcf2poolgood.1xxAddPool,algorithmdoes一、pool_idpool_id1del_pool100del_pool100“DelPool,thisalgorithmshave“DelPool,thisalgorithmshavenotthisdel_pool1btcdel_pool be