autoform material parameter setting discussion result材料參數設置討論結果

1、1Autoform材料參數設置討論結果 Autoform material parameter setting1：高強板的劃分統一定義如下：HSS definition:屈服強度Ys小于300MPa的按普通板來設置，屈服強度Ys大于等于300MPa以高強度板來設置。HSS: Yield Strength 300Mpa LSS: Yield Strength 300Mpa2: 針對寶鋼提供的材料參數，現在統一用Average值去設定，見圖1。All the material parameter setting used Average Value. Attached drawing 1.3：Ha

2、rdening curve根據寶鋼提供的參數，用Ludwik選項，見圖2。Hardening curve option: Ludwik. Attached drawing 2.4：Yield surface 根據寶鋼提供的參數， 用Hill選項。Yield surface option: Hill其中高強度板Biax項設置為1.2（Hill 90），非高強度板Biax項設置為1.0 (Hill 48)。If HSS: Biax option1.2(Hill 90). If LSS: Biax option1.0(Hill 48)5：FLC這一項中非高強度板用Keeler選項，高強度板用Arce

3、lor V9選項。FLC option:If HSS: Arcelor V9 . If LSS: Keeler6：考慮FLC曲線位置，現對每個料厚產生對應的*.mtb用于軟件分析, 而其他參數保持不變，見圖3。Considering the FLC position, build *.mtb to each thickness material(0.53.5) but keep other parameters, Attached drawing 3.7：后續如材料或軟件提升，材料庫需討論后同時更新。If the material or software updated, Autoform material setting also will be updated but must need to discuss each other.2高強度板用1.2，非高強度板用1.0. HSS:1.2 LSS:1.0高強度板用Arcelor V9，非高強度板用KeelerHSS: Arcelor