mep-tc spec services testing and commissioning rev曼氏香精香料廠房工程

1、MANE China New Factory Project曼氏（中國）香精香料新建廠房工程General Contractor Package總包投標文件ationMEP Specifications機電技術要求MEP-SPEC-07TESTING AND COMMISFIRE SERVIING消 防 設 施 的 測 試 和 調 試說 明：曼氏（中國）香精香料Package Owner: MANE (China) FRAGRANCE AND FLAVOUR CO.,.版次：0 Revi: 0編制日期：2017 年 01 月 20 日Preparation Date: Jan. 20th 20

2、17項目名稱：曼氏（中國）香精香料Project: MANE China New Factory Project新建廠房工程Table of Contents 目 錄11.11.2Testing Procedures 測 試 程 序General 概 述Visual Inspection 目測22.12.22.32.4Electrical Systems 電 氣 系 統Auto Fire detection System 自 動 火 警 探 測 系 統Activated devi激活設備Audio & Visual Alarm devi聲光Emergency warning system 緊

3、急設施系 統33.1Hydraulic system 水力 系 統Pi管 道1.0Testing Procedures 測試程序1.1General 概述Supply apparatus and materials nesary for, and carry out the commising, and testsspecified herein, or required by the Fire Inspectors, Supervi presence of the Project Managers represenive.unit, and Fire Bureau,he應提供進行調試和測試所

4、需的設備和材料，這里所指的測試是指應消所要求的，并在項目經理的代表參與下所進行的。查員、監理和消防局等All tests should be carried out in a manual mode of operation as well as simulating an automatic emergency condition.所有的測試都為手工操作，并模擬自動緊急情況。Tests listed here are a minimum requirement and the contractor shall perform all ne testing and inspections to

5、 the satisfaction of the Project Manager and Authorities.sary這里列出的測試均為最低要求 ，承包商必須按項目經理和當?shù)卦嚭蜋z查。部門要求進行所有必要的測1.2Visual Inspection 目測A detailed inspection shall precede testing and should be carried out with the section of the Works under inspection disconnected from the supply.在測試之前要進行仔細的檢查，檢查進行時測試區域應斷

6、電。The detailed inspection shall confirmt the Works have been installed in accordance with thedesign and include, but not be limited to, verificationt:應進行仔細的檢查以確保安裝與設計相一致，并至少應確認：Equipment comp s with the specified standards, has been properly selected and erectedand is not visibly damaged or defectiv

7、e so as to impair safety, and has been provided.t adequate acs設備符合規范，其選型合理，安裝正確，且沒有會會影響安全操作的明顯的損壞，并且便于維修。Appropriate isolating and switching devihave been provided andt protective andmonitoring devihave been appropriay chosen and set.應安裝合適的絕緣和開關設備，并且已經選擇和設置了合適的保護和設備。Identification labeling has been

8、properly provided for circuits, switches, fuses andterminals, andt operating diagrams and instructions, together with danger and warningnoti, are in place.應在電路，開關，保險絲和接線端已經貼上可識別的，并設有操作說明和警告。Pipework has been paed to the requirement of the specification.管道已按說明的要求油漆好。Penetrations through fire walls ha

9、ve been sealed in an approved manner.應對中縫隙按認可的方式填充。2.0Electrical systems 電氣系統21.Automatic Fire Detection System 自動火警探測系統Ensure fire detection equipment comp s with clearance measurements from air outlet grilles and the like.應確?；馂?zāi)檢測設備與風口保持一定的測量間距。Each component group，should be separay functionally te

10、sted. Each function check shouldbe carried ouleast twice.每個組件均需單獨進行功能測試。每次功能測測試至少進行兩次。Function checks should include, but not be limited to, for verification功 能 測 試至少應包括以下內容：t:erlocking and overriding deviensuret the overall sequence of control is achieved.應提供連鎖和過載設備以確保整個控制按序進行。Equipment protection

11、devi設備保護設施運行良好operate satisfactorily.Deviactivated by fire alarm operate satisfactorily.與火警裝置聯動的設備運做良好Safety is not jeopardised突然斷電時不危及安全he event of theerruption of the electrical supply.Smoke detectors shall be tested using an approved smoke source. Activating the sensor to ensure both the red indi

12、cating light is illuminated (on the sensor) and the alarm haivated the FAP使用認可的煙源檢測感煙探測器。激活探測器以確保探測器上的紅色指示燈點亮，并且激活火災盤。Heat detectors shall be tested using an approved heat source. Activating the sensor to ensureboth the red indicating light is illuminated (on the sensor) and the alarm haivated the F

13、AP使用認可的熱源檢測溫?zé)熖綔y(cè)器。激活探測器以確保探測器上的紅色指示燈點亮，并且激活火災盤。Carryoommising tests to the requirement of the functional Specifications and drawings.按設計說明和圖紙的要求進行調試。Every function of the FAP shall be tested and verified in accordance with the approved design and performance criteria.火災盤的每項功能都均測試和校準， 且應與過的設計技性能參數相一致。

14、2.2Activated devi激活設備Test the functional operation of: 測試下列設備的功能Fire doors 防火門Smoke and fire ders. 排煙防火閥HVAC equipment 暖通設備Electricalerlocking devi電氣連鎖設施2.3Audio & Visual Alarm devi聲光設施Test the functional operation of: 測試下列設備的功能Audio alarms, i.e. Bells, sirens 聲音， 如： 警鈴，器Visual system, i.e. strobes,

15、 flashing lights 光系統， 如：閃光燈2.4Emergency Warning Systems 緊急系統Carryoommising tests to the requirement of this 9+Specification.應按此說明的要求進行調試。Check the functioning of the PACP.檢查公共廣播控制盤的功能。3.03.1Hydraulic systems 水力系統Pi管道Hydrosic Tests 水壓測試Maain a test prere of 1.5 times theum sic working prere forriod of 24hours orif nesary to complete the inspection of pipework under test.管道測試壓力為最大工作壓力的 1.5 倍，并保持 24 小時或以上（如果需要的話）。W