文稿其它教程day

1、Pre-Process(build model)in HyperMeshTranslate resultsto HM .res filePost-Process(view results)in HyperMeshDesign in CAD softwareRun Analysisin FEA solverImport CADdataExport FEAmodelHeader BarMacro MenuMain panel menuGraphics AreaPermanent MenuPage selection menuIncremental rotationRotate the model

2、in the direction of the indicated arrowVertically, about the horizontal screen axisHorizontally, about the vertical screen axisRotate within the plane of the screenCircle ZoomMagnify the view of a specific area of the model by drawing a circle around it in the graphics areaScreen Refresh (re-paint)R

3、edraw the graphics on the screenModel FitFit the active model to fill the graphics areaDynamic RotateRotate the model in the direction of the vector created between the rotation center and the mouse cursor. Rotation speed corresponds to the length of the vectorSlide ZoomZoom in to the center of the

4、model by clicking and dragging the mouse vertically within the graphics areaPick CenterRedefine the model center by picking a new point in the graphics area. Can also be used to “translate” the modelTrue ViewDefine your view of the model based on a model vector of anglesArc RotateRotate the model by

5、 “grabbing” it at a point and dragging it in the direction of the mouse movementIncremental ZoomZoom in or out from the model by a set zoom factorToggle View (back to previous view)return to the last view, before the last zooming or rotation operation. Used to toggle back and forth between any two v

6、iewsNote: any of the above functions can be activated using the corresponding key on the keyboardView menuPop-up menu to set a predefined view or save and restore user-defined viewsOptions MenuSet modeling tolerances and defaults, select graphics modes, activate the macro menu, set the screen colors

7、, postscript and spaceball optionsCard EditorPreview the model informatin in the solver-specific card image formatGlobal Settingssettings affecting model and element creation. Load template, results file, set active collector, set finite element default size and orderHelpLaunch the interactive on-li

8、ne help system. If selected while in a panel, help for that panel will be displayed. If selected from the main page menu, the entire help book structure will be displayedDisplayTurn on or off the display of individual collectors. Model BrowserLaunch the model browser to control display and visibilit

9、y optionsdetailsVisability optionsWhen in performance graphics mode, control the visibility mode of individual componentsWireframeShaded, no linesShaded, mesh linesShaded, feature linesTransparentVector fromnode N1 to N2Plane defined using nodes N1 N2 and N3Direction is normal to plane at N1 or othe

10、r base nodeDoubleClickComponentscontain elements, lines, surfaces, pointsLoad Collectorsorganize boundary conditions (forces, pressures, moments, constraints)Property Collectorselement property information for 1-D elementsMaterial Collectorsmaterial database informationSystem Collectorslocal coordin

11、ate systemsGroupsrestricted component collector used to support advanced solver featuresAssembliesorganize components into logical unitsnodeelementcomponentmaterialNode to element referenceHyperMesh componentHyperMesh materialElement to component referenceHyperMesh elementHyperMesh nodeComponent to

12、material referenceModel a spring with hex elements and subject it to loads in two different directions at one end, while fully constraining the opposite endSolve using Altairs OptiStruct linear static solver and post process in HyperMesh Free edgesEdges belonging to a single surfacecan result in mesh discontinuity if interior to model Shared edgesedges common to two adjacent surfacesnodes on shared edges common to both surfacesSuppre