ADI-ADuM6420A帶DC／DC轉換器的四道數字隔離器解決技術方案

1、AO-Electronics傲壹電子官網：中文網：ADI ADuM6420A帶DCDC轉換器的四道數字隔離器解決方案 ADI公司的ADuM6420A/ADuM6421A/ADuM6422A是采用isoPower集成隔離式直流/直流轉換器的四通道數字隔離器.基于 ADI 公司的iCoupler技術,可提供穩壓隔離式電源,在配備鐵氧體的 2 層印刷電路板(PCB)上在滿載時符合 CISPR 32/EN 55032 B 級限制.100mA輸出電流,滿足AEC-Q100汽車應用規范, 在 500 mW的隔離式設計中不再需要單獨的隔離式直流/直流轉換器.具有四路DC到100Mbps信號隔離通路,可提供外

2、形小巧四個獨立的完全隔離式解決方案.高溫125C工作溫度,共模瞬態免疫為100 kV/s, VIORM = 566 V peak.主要用在RS-232 收發器,電源啟動偏置和柵極驅動,隔離式傳感器接口和工業可編程邏輯控制器(PLC)以及汽車車載充電器(OBC)和DC/DC轉換器.本文介紹了ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A主要特性,功能框圖,.評估板EVAL-ADUM6421ARNZ/ EVAL-ADUM6421AURNZ主要特性,電路圖,材料清單和PCB設計圖.The ADuM6420A/ADuM6421A/ADuM6422A

3、/ADuM6423A/ ADuM6424A1 are quad-channel digital isolators with an isoPower, integrated, isolated dc-to-dc converter. Based on the Analog Devices, Inc., iCoupler technology, the dc-to-dc converter provides regulated, isolated power that meets CISPR 32/EN 55032 Class B limits at a full load on a 2-lay

4、er printed circuit board (PCB) with ferrites. Popular voltage combinations and the associated output current levels are listed in Table 1.The ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A eliminate the need for a separate, isolated dc-to-dc converter in 500 mW, isolated designs. The iCoupler ch

5、ip scale transformer technology is used for isolated logic signals and for the magnetic components of the dc-to-dc converter. The result is a small form factor, total isolation solution.The ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A isolators provide four independent isolation channels (see

6、the Pin Configurations and Function Descriptions for additional information).ADuM6420A主要特性:isoPower integrated, isolated dc-to-dc converter100 mA output supplyAEC-Q100 qualified for automotive applicationsADuM6421AW (ADuM6423AW pending)Meets CISPR 32/EN55032 Class B emission limits up to 5 Mbps at a

7、 full load on a 2-layer PCBQuad dc to 100 Mbps signal isolation channels28-lead, fine pitch, SOIC with 8.3 mm minimum creepageHigh temperature operation: 125C maximumHigh common-mode transient immunity: 100 kV/sSafety and regulatory approvals (pending)UL recognition (pending)5000 V rms for 1 minute

8、per UL 1577CSA Component Acceptance Notice 5A (pending)VDE V 0884-11 certificate of conformity (pending)VIORM = 566 V peakCQC certification per GB4943.1-2011 (pending)ADuM6420A應用:RS-232 transceiversPower supply start-up bias and gate drivesIsolated sensor interfacesAutomotive on-board charger (OBC)

9、and dc to dcIndustrial programmable logic controllers (PLCs)圖1.ADuM6420A功能框圖評估板EVAL-ADUM6421ARNZThe ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A devices integrate four iCoupler on-off keying (OOK) digital isolation channels and iCoupler chip scale isoPower transformer technology.This iCoupler

10、transformer technology enables a small form factor integrated, reinforced isolated signal and power solution, in applications requiring up to 500 mW of isolated power.Available dc-to-dc converter supply configurations and maximum available power at the elevated ambient temperatures are specified in

11、the ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A data sheet.The ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A devices provide regulated, isolated power that meets CISPR 32/EN 55032, Class B limits at full load on a 2-layer printed circuit board (PCB) with ferrite beads. Radiated emissions

12、 test plots of the EVAL-ADUM6421ARNZ/EVAL-ADUM6421AURNZ are provided in Figure 4 and Figure 5. All devices in the family include the same isolated dc-to-dc converter and are differentiated by directional digital channel configurations.The EVAL-ADUM6421ARNZ includes the ADuM6421ABRNZ5 quad-channel di

13、gital isolator with integrated, isolated dc-to-dc converter. Alternatively, the EVAL-ADUM6421AURNZ leaves the isolator position unpopulated to support evaluation of the ADuM6420A, ADuM6421A, ADuM6422A, ADuM6423A, or ADuM6424A.Full specifications for the ADuM6420A/ADuM6421A/ ADuM6422A/ADuM6423A/ADuM6

14、424A are available in the ADuM6420A/ADuM6421A/ADuM6422A/ADuM6423A/ ADuM6424A data sheet, which must be consulted in conjunction with this user guide when using the evaluation boards.評估板EVAL-ADUM6421ARNZ主要特性:isoPower integrated, isolated dc-to-dc converterMeets CISPR 32/EN 55032, Class B emission lim

15、itsOn-board 6 V to 9 V LDO power supply that provides 5 V to the VDDP pin5 V input operation and selectable 3.3 V or 5 V isolated dc-to-dc converter outputScrew terminal connectors for the followingLDO power supply5 V direct power supplyOff board PDIS controlIsolated output supplyEVALUATION KIT CONTENTSEVAL-ADUM6421ARNZ, includes the ADuM6421ABRNZ5EVAL-ADUM6421AURNZ, requires the ADuM6420A, ADuM6421A, ADuM6422A, ADuM6423A, or ADuM6424A to be ordered separately圖2.評估板